Juhi Electricals Pvt. Ltd. is a small scale Industry but its dreams are high. Challenges are acceptable. We try to maintain the quality, time schedule and high standards.
- Our Panel Boards are type tested at Central Power Research Institute, Bhopal.
- All Feeders starters or switchgears are installed in separate chambers. Separate Bus Bar sections, Cable Alleys are provided to make the panel boards fully compartmentalized and fault free.
- Aluminium or Copper Bus Bars are rigidly supported on high value breaking capacity DMC/SMC insulator or Bakelite.
- Panel Boards may be fully front operated, Backside doors of panel boards are fixed with the bolts.
- Panel boards can be made for back operation too whenever needed.
- Floor mounting panels with the 75x40 mm base channel.
- Wall mounting Panels.
- To make Panel boards dust and vermin proof, rubber gasket is used.
- All Bus Bars are sleeved.
- All Control and power wiring is done with fire proof 1100v grade Cu wire cables.
What is the Need of Panels Read more...
The Panel Boards are needed to distribute the power in proper manner. Basically panel Boards are based on Bus System where a main protection breaker is provided and sub feeders are connected by bus bars either Aluminum or copper strips and where not possible, by wires. All feeders are protected by the required switchgears. The Breakers are designed to protect the circuits against short circuit, overload, earth faults etc. Whenever any improper functioning occurs during the operation, these breakers open the circuits to avoid the major damages.